Wiper Arm Linkage - Installation

INSTALLATION






NOTE: The front wiper motor can be removed from the wiper linkage module and is serviced independently from the remainder of the wiper linkage module for this vehicle. Front Wiper Motor - Removal.

1. Position the front wiper linkage module into the cowl plenum as a unit.
2. Engage the wire harness retainer (1) with the linkage module bracket.
3. Reconnect the wire harness connector (2) to the connector receptacle for the front wiper motor.
4. Engage the knob-like rubber insulator into the hole in the rearward wall of the cowl plenum.
5. Install and tighten the left screw (3) that secures the module bracket to the cowl plenum, followed by the right screw. Tighten the screws to 9 Nm (80 in. lbs.).
6. Reinstall the cowl plenum cover/grille panel over the front wiper linkage module. Cowl Panel Cover - Installation.

NOTE: Be certain to turn the ignition switch to the ON position, then turn the front wiper switch ON and OFF again to cycle the wiper motor and linkage to their natural park position before reinstalling the front wiper arms onto the wiper pivots.

7. Reinstall both front wiper arms onto the wiper pivots. Front Wiper Arm - Installation.
8. Reconnect the battery negative cable.