Right Multifunction Switch - Description

DESCRIPTION





The right multi-function switch is located on the right side of the steering column, just below the steering wheel. This switch is the primary control for the front and rear wiper and washer systems. The only visible components of the switch are the control stalk (7) and the control knob (6) that extend through the steering column shrouds on the left side of the column. The remainder of the switch including its mounting provisions and its electrical connections are concealed beneath the shrouds.

The switch housing and controls are constructed of molded black plastic. Each of the switch controls has white International Control and Display Symbol graphics applied to it, which clearly identify its many functions. The right (wiper) multi-function switch for this vehicle is integral to the clockspring.

The right multi-function switch provides the vehicle operator with a control interface for the following wiper and washer system functions:

- Continuous Front Wipers - The right multi-function switch control stalk provides detent switching for two continuous front wipe modes, low speed or high speed.
- Intermittent Front Wipers - The right multi-function switch control stalk provides detent switching for the speed-sensitive intermittent front wipe mode.
- Front Wiper Mist Mode - The right multi-function switch control stalk includes momentary switching of the front wiper motor low speed circuit to provide a mist mode feature (sometimes referred to as pulse wipe), which allows the vehicle operator to momentarily operate the front wipers for one or more complete cycles.
- Front Washer Mode - The right multi-function switch control stalk provides momentary switching for control of the front washer system operation.
- Intermittent Rear Wipe Mode - The right multi-function switch control knob provides detent switching for a single fixed interval intermittent rear wiper mode.
- Rear Washer Mode - The right multi-function switch control stalk provides momentary switching for control of rear washer system operation.

In addition, a small TRIP push button at the very end of the right multi-function switch control knob provides a signal to the Instrument Panel Cluster (IPC) that will reset the currently displayed trip odometer A or B value to zero.

The right multi-function switch cannot be adjusted or repaired. If any function of the switch is ineffective, or if the switch is damaged, the entire clockspring unit with both the left and right multi-function switches must be replaced. Clockspring - Removal.