B1006-13

B1006-13-FUEL LEVEL SENSOR - CIRCUIT OPEN

For a complete wiring diagram, refer to the Wiring Information.

Theory of Operation

The Body Control Module (BCM) monitors the voltage on the fuel level signal circuit. The voltage value is then transmitted as a network message on the communication network.

- When Monitored:
With the ignition on.

Battery voltage greater than 10.4 volts.

- Set Condition:
The Body Control Module (BCM) detects that the Fuel Level Sensor input is open for more than 10 seconds.





1. CHECK FOR AN INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. With the scan tool, read DTCs.

Does the scan tool display DTC: B1006-13-FUEL LEVEL SENSOR - CIRCUIT OPEN?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. CHECK THE FUEL LEVEL SENSOR FOR CORRECT OPERATION
1. Turn the ignition off.
2. Disconnect the Fuel Pump Module C1 harness connector.
3. Connect a jumper wire between the (N4) Fuel Level Sensor Signal circuit and the (G109) Fuel Level Sense Return circuit at the Fuel Pump Module C1 harness connector.
4. Turn the ignition on.
5. With the scan tool, read DTCs.

Does the scan tool display DTC: B1006-11-FUEL LEVEL SENSOR - CIRCUIT SHORT TO GROUND?

Yes

- Replace the Fuel Level Sending Unit. Fuel Pump Module - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. CHECK THE (N4) FUEL LEVEL SENSOR SIGNAL CIRCUIT FOR AN OPEN
1. Turn the ignition off.
2. Disconnect the BCM C2 harness connector.
3. Measure the resistance of the (N4) Fuel Level Sensor Signal circuit between the Fuel Pump Module C1 harness connector and the BCM C2 harness connector.

Is the resistance below 5.0 Ohms?

Yes

- Go To 4

No

- Repair the open in the (N4) Fuel Level Sensor Signal circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

4. CHECK THE (G109) FUEL LEVEL SENSE RETURN CIRCUIT FOR AN OPEN
1. Measure the resistance of the (G109) Fuel Level Sense Return circuit between the Fuel Pump Module C1 harness connector and the BCM C2 harness connector.

Is the resistance below 5.0 Ohms?

Yes

- Go To 5

No

- Repair the open in the (G109) Fuel Level Sense Return circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

5. BODY CONTROL MODULE (BCM)
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the Fuel Pump Module and the BCM.
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals. Verify that there is good pin to terminal contact in the Fuel Pump Module and the BCM harness connectors.
4. Perform any Technical Service Bulletins (TSB)s that may apply.

Were any problems found?

Yes

- Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the BCM. Body Control Module - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.