Operation CHARM: Car repair manuals for everyone.

C1002-1C






C1002-1C-TORQUE POSITION SENSOR-CIRCUIT VOLTAGE OUT OF RANGE

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuous.

- Set Condition:
The Electric Power Steering (EPS) Module receives an invalid signal from the torque or position sensor.





DTC IS ACTIVE

NOTE: If multiple DTCs are present, inspect the wiring and harness connector at the EPS Assembly.

1. Turn ignition on.
2. With the scan tool, record and erase DTCs.
3. With the scan tool, read the DTCs in the EPS Module.

Is the DTC status Active?

Yes

- Replace the Electronic Power Steering (EPS) Assembly. Steering Column - Removal.
- Perform the EPS VERIFICATION TEST. EPS Verification Test.

No

- Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.