C1214-01

C1214-01-YAW/LATERAL/LONGITUDINAL SENSOR CLUSTER - GENERAL ELECTRICAL FAILURE





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on and no system under voltage or over voltage condition present.

- Set Condition:
When the Dynamics Sensor has detected an over or under voltage.





1. VERIFY THE DTC IS ACTIVE

NOTE: This DTC must be active for the results of this test to be valid.

1. Turn the ignition on.
2. With the scan tool, read and record DTCs.
3. With the scan tool, read and record Freeze Fame information.
4. With the scan tool, erase DTCs.
5. Start the engine.
6. Press the brake pedal firmly and release.
7. With the scan tool, read and record DTCs.

Is the DTC active at this time?

Yes

- Go To 2

No

- Perform ABS-INTERMITTENT CONDITION TEST ABS Intermittent Condition Test.

2. POWER CIRCUIT OPEN OR SHORTED




1. Turn the ignition off.
2. Disconnect the Dynamics Sensor harness connector.
3. Using a 12-volt test light connected to ground, check the Fused B(+) circuit.

Does the test light illuminate brightly?

Yes

- Go To 3

No

- Repair the Fused B(+) circuit for an open or short.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

3. GROUND CIRCUIT OPEN




1. Using a 12-volt test light connected to 12-volts, check the (Z910) Ground circuit.

Does the test light illuminate brightly?

Yes

- Replace the Dynamics Sensor. Dynamics Sensor - Removal.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

No

- Repair the Ground circuit for an open.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.