P0832

P0832-CLUTCH PEDAL SWITCH 1 CIRCUIT HIGH

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Engine running. Battery voltage greater than 10.4 Volts.

- Set Condition:
The Powertrain Control Module (PCM) receives a signal from the Clutch Interlock Switch indicating that the clutch pedal is depressed while the vehicle is driven.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.

Diagnostic Test

1. ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
1. Ignition on, engine not running.
2. With a scan tool, monitor the Clutch Upstop Switch state while pressing and releasing the clutch pedal.

Does the clutch pedal state change when pressing and releasing the clutch pedal?

Yes

- Perform the INTERMITTENT CONDITION diagnostic procedure. Intermittent Condition Test.

No

- Go To 2

2. CLUTCH SWITCH




1. Turn the ignition off.
2. Disconnect the Clutch Switch harness connector.

NOTE: Check connectors - Clean/repair as necessary.

3. Connect a jumper wire between terminal one and terminal three of the Clutch Switch circuit harness connector.
4. Turn the ignition on.
5. Using the scan tool, monitor the Clutch Upstop status.

NOTE: The scan tool should display the Clutch Upstop Switch status as not pressed with the jumper wire in place and pressed with the jumper wire removed.

Does the scan tool display the status as described above?

Yes

- Replace the Clutch Switch.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.

No

- Go To 3

3. CLUTCH UPSTOP SWITCH SIGNAL CIRCUIT SHORTED TO VOLTAGE




1. Disconnect the PCM C1 harness connector.
2. Disconnect the ASD Relay connector.
3. Connect a jumper wire between pin 30 and pin 87 of the ASD Relay connector.
4. Ignition on, engine not running.
5. Turn off all accessories.
6. Measure the voltage of the Clutch Upstop Switch Signal circuit.

Is there any voltage present?

Yes

- Repair the short to voltage in the Clutch Upstop Switch Signal circuit.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.

No

- Go To 4

4. POWERTRAIN CONTROL MODULE (PCM)
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the Clutch Interlock Switch and the Powertrain Control Module (PCM).
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals.
4. Verify that there is good pin to terminal contact in the Clutch Interlock Switch and PCM harness connectors.
5. Perform any Technical Service Bulletins (TSBs) that may apply.

Were there any problems found?

Yes

- Repair as necessary.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.

No

- Replace and program the Powertrain Control Module.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.