Upper

UPPER

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the instrument panel switch pod (3) to the back of the instrument panel center bezel (2).
2. Install, and tighten the screws that secure the switch pod to the bezel.
3. Install the center bezel, Instrument Panel Center Bezel - Installation.
4. Connect the negative battery cable.