Operation CHARM: Car repair manuals for everyone.

Exterior Handle Lamp Bar - Installation






INSTALLATION





1. Connect the license plate light (3) electrical connector.
2. Align the base of the light housing (3) with the socket in the outboard side of the license plate lamp/ liftgate switch housing.
3. Push the light housing straight into the socket until the base is firmly seated and the lock (2) engages.





4. Position the housing onto the liftgate.
5. Engage the two tabs on the inboard side of the housing into the slots on the liftgate.

6. Open the liftgate




7. Install the four housing support nuts (1). Tighten the nuts to 60 Nm (44 ft.lbs.)





8. Connect the electrical connector.





9. Install the liftgate trim panel.
10. Reconnect the battery negative cable.