In Vehicle
ON VEHICLE
Special Tools:
1. If removed, install the spring seat (3) and valve guide seal (2) over the valve guide Valve Guide Seals - Installation.
NOTE: Make sure that the garter spring (1) is intact around the top of the valve guide seal (2). Number 2 cylinder exhaust valve guide seal shown, all other valves similar.
NOTE: If the valve springs are being reused, reassemble them into their original locations. Number 2 cylinder exhaust valve spring shown, all other valves similar.
2. Install the valve spring (2) and valve spring retainer (1).
NOTE: Number 3 cylinder exhaust valve spring compression shown, all other valves similar.
3. Using the (10224) (3) with the (MD998772A) (2), compress the valve spring (5) only enough to install the valve retaining locks (4).
4. Relieve the air pressure and remove the spark plug adapter.
5. Install the spark plug and tighten to 19 Nm (14 ft. lbs.) Spark Plug - Installation.
6. Install the camshaft bearing housing Camshaft Bearing Housing - Installation.
7. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).