Off Vehicle

OFF VEHICLE

Special Tools:










1. If removed, install the valve(s) Intake And Exhaust Valves - Installation.

NOTE: Reassemble the valves into their original locations. If the valves or valve seats have been refinished, verify that the valve stem tip height is within specification Engine Specifications.

2. If removed, install the spring seat (3) and valve guide seal (2) over the valve guide Valve Guide Seals - Installation.

NOTE: Make sure that the garter spring (1) is intact around the top of the valve guide seal (2). Number 2 cylinder exhaust valve guide seal shown, all other valves similar.







NOTE: If the valve springs are being reused, reassemble them into their original locations. Number 2 cylinder exhaust valve spring shown, all other valves similar.

3. Install the valve spring (2) and valve spring retainer (1).






NOTE: Number 3 cylinder exhaust valve spring compression shown, all other valves similar. If the valves or valve seats have been refinished, verify that the installed height of the valve springs is within specification Engine Specifications.

4. Compress valve springs (4) with the (10224) (1) mounted in the (C-3422-D) (2). Install the retaining locks (3) and release the valve spring compression.
5. Install the cylinder head Cylinder Head - Installation.