Engine Oil Cooler - Installation

INSTALLATION





1. Install the new oil cooler seal (1) onto the oil filter housing.





2. Position the oil cooler (1) on the oil filter housing.
3. Install six bolts (2) and tighten to 9 Nm (80 in. lbs.).





4. Install the lower oil cooler housing heatshield (2) with four bolts (3) tightened to 3 Nm (26 in. lbs.).
5. Fill the engine crankcase with the proper oil to the correct level Service and Repair.
6. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
7. Fill the cooling system Service and Repair.
8. Operate the engine until it reaches normal operating temperature. Check cooling system for correct fluid level Service and Repair.