Piston Oil Cooler Jet - Installation

INSTALLATION






NOTE: Piston oil cooler jet for cylinder three shown. Piston oil cooler jets for cylinders one, two and four are similar.

1. Using a suitable driver (1), install the piston oil cooler jet(s) (2) into the engine block.
2. Install the crankshaft Crankshaft - Installation.
3. Install the piston and connecting rod(s) Piston And Connecting Rod - Installation.
4. If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level Service and Repair.
5. Fill the cooling system Service and Repair.
6. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
7. Run the engine until it reaches normal operating temperature. Check cooling system for correct fluid level Service and Repair.