Blower Motor - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: Manual Temperature Control (MTC) shown. Automatic Temperature Control (ATC) similar.





1. Disconnect and isolate the negative battery cable.
2. Reach up behind the left side of the instrument panel and disconnect the wire harness connector (2) from the blower motor (4).
3. Remove the three screws (1 and 3) that secure the blower motor to the HVAC housing (5) and remove the blower motor.