Automatic Temperature Control (ATC) System

AUTOMATIC TEMPERATURE CONTROL (ATC)





1. Position the A/C heater control (1) to the instrument panel and connect the HVAC wire harness connector (2).





2. Install the instrument panel cover Instrument Panel Cover - Installation.
3. Install the four screws (2, 3, 5 and 6) that secure the A/C heater control (1) to the instrument panel cover (4). Tighten the screws securely.
4. Install the instrument panel center bezel Instrument Panel Center Bezel - Installation.





5. Position the control panel (3) to the instrument panel and connect the HVAC wire harness connector (2) to the accessory switch pod (1).





6. Position the control panel (1) to the instrument panel (2) and engage the retaining tabs that secure the panel to the A/C heater control. Make sure the retaining tabs are fully engaged.
7. Reconnect the negative battery cable.
8. Initiate the Actuator Calibration function using a scan tool .