Stop Lamp Switch - Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

CAUTION: Never remove or install the brake lamp switch while the brake pedal arm is disassembled from the brake booster push rod.

CAUTION: Do not depress, lift or move the brake pedal during brake lamp switch removal to avoid switch damage. Do not depress, lift or move the brake pedal during brake lamp switch installation to avoid improper switch adjustment.





1. Disconnect and isolate the battery negative cable.
2. Locate the brake lamp switch (1) on the brake pedal support bracket (3) on the dash panel under the instrument panel.
3. Disconnect the body wire harness connector from the brake lamp switch.
4. Press the brake lamp switch against the bracket while rotating the switch housing clockwise about 45 degrees to align the tabs on the switch locking collar with the keyed hole in the brake pedal support bracket.
5. Pull the switch straight away from the keyed hole to remove it from the bracket.
6. Remove the switch from the vehicle.