Turn Signal Bulb - Installation

BULB - TURN SIGNAL

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

NOTE: The upper front combination lamp unit combines the low beam headlamp bulb and the turn signal lamp bulb in a single lamp unit. This lamp is used only on vehicles manufactured for sale in Mexico and Latin America and replaces the headlamp unit used on vehicles manufactured for sale in the United States and Canada.





1. Align the base of the bulb (1) with the bulb socket (2).
2. Push the bulb straight into the socket until the base is firmly seated.





3. Align the socket (2) and bulb with the keyed opening on the back of the headlamp reflector.
4. Insert the socket and bulb into the reflector until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reinstall the protective rubber boot over the upper opening on the back of the upper front combination lamp unit housing (1).
7. Reconnect the battery negative cable.