Operation CHARM: Car repair manuals for everyone.

Fuel Pump Module - Installation





INSTALLATION

Special Tools:










1. Align the fuel pump module to the alignment tabs for proper sending unit float operation.
2. Using a new seal (gasket), install the fuel pump module (4) into the fuel tank opening.
3. Position the locking (3) over top of fuel pump module (4).
4. Install the fuel pump module locking ring (3) using SAE Fuel Pump Lock Ring Wrench 9340 (2). Position the tool into the locking ring and turn the ring till the tabs are locked into the notches.





5. Connect the return (1), fuel supply (2), and vapor (3) lines to the fuel pump module Service and Repair.





6. Connect the fuel pump module wiring harness connector (4).
7. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lb.).

NOTE: Allow time for air to purge from the fuel lines.

8. Start the engine and check for leaks at all fuel pump module connections.
9. Position the fuel pump module cover (1) into position and tighten the screws (2).





10. Install the rear lower seat cushion (1). Guide the seat belt latches through the rear of the seat.
11. Install the seat mounting bolts (3) and tighten to 40 Nm (30 ft. lbs.).