Park Assist Sensor - Removal

REMOVAL

NOTE: The park assist sensors and the sensor O-ring spacers are each available for separate service replacement. The following service procedure can be used for reassembling any or all of these components to the rear bumper fascia.

WARNING: The outside sensors are located in the area of the engine exhaust; allow exhaust to cool before accessing the sensors. Failure to follow these instructions may result in personal injury.





1. Disconnect and isolate the negative battery cable.
2. From the back of the fascia, disconnect the wire harness connector from the park assist sensor connector receptacle (1).
3. Carefully pry the sensor bracket latch features (2) away from the top and bottom tabs of the sensor far enough to disengage the sensor from the bracket.





4. Separate the sensor spacer (2) from the sensor.