Output Shaft Assembly - Disassembly
DISASSEMBLY
Special Tools:
1. Remove the fourth speed driven gear using Bearing Splitter (P-334).
2. Remove the fourth gear to third gear spacer.
3. Remove the third and second driven gears using Bearing Splitter (P-334).
4. Remove the first/second gear synchronizer and slider ring (1).
5. Remove the needle bearing from the shaft.
6. Remove the snap ring (1).
7. Remove the first driven gear and the first/second synchronizer hub using Bearing Splitter (P-334).
8. Remove the needle bearing from the shaft.
9. Remove the snap ring.
10. Remove the rear bearing from the shaft using Bearing Splitter (P-334).