C514 Manual Transaxle - Removal

REMOVAL

1. Remove battery tray Battery Tray - Removal.
2. Remove air cleaner assembly Air Cleaner - Removal.




3. Remove the ground strap (1) from the transmission.





4. Disconnect reverse lamp switch connector (1).





5. Remove the slave cylinder bolts (1) and secure the cylinder out of the way.





6. Disconnect shift selector cable (1) from the lever.





7. Disconnect the cable from the mounting bracket (1).





8. Disconnect the shift cable (1) from lever.





9. Disconnect the cable from the bracket (1).





10. Remove upper bell housing bolts (1).

11. Remove the upper starter bolts
12. Raise vehicle on hoist.
13. Remove the belly pan if equipped Belly Pan - Removal.




14. Remove the cross car cradle brace (1).

15. Drain the transaxle fluid Service and Repair
16. Remove both halfshaftsHalf Shaft - Removal.
17. Remove the Front Fascia Front Bumper Fascia - Removal.




18. Remove two bolts (1) and the left vertical brace from the vehicle.





19. Remove four bolts (2) and the left lower frame extension (1).





20. Disconnect the oxygen sensor wire from the loom/clip (1).
21. Carefully support the engine with a screw jack or the equivalent.
22. Install a suitable transmission jack to the transmission.





23. Remove the left side bolts (1) and mount.





24. Remove the rear transmission mount bolt (1) from the frame.





25. Remove the rear transmission mount bracket bolt (1) and bracket from transmission.





26. Remove the remaining transmission bell housing bolts (3).
27. Remove the nut (1) and the stud (2) from the transmission case to facilitate removal.
28. Remove transaxle from vehicle.