Service Procedure

NOTE:
wiTECH must be used to perform this recall. This procedure must be performed with software release level 13.03 or higher. If the reprogramming flash for the PCM is aborted or interrupted, repeat the procedure.

A. Reprogram the Powertrain Control Module:

1. Open the hood. Install a battery charger and verify that the charging rate provides 13.0 to 13.5 volts. Do not allow the charger to time out during the flash process. Set the battery charger timer (if so equipped) to continuous charge.

NOTE:
Use an accurate stand-alone voltmeter. The battery charger volt meter may not be sufficiently accurate. Voltages outside of the specified range will cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower motor to lower the voltage.

2. Connect the wiTECH VCI pod to the vehicle data link connector located to the right of the hood release lever.

3. Place the ignition in the "RUN" position.

4. Open the wiTECH Diagnostic application.

5. Starting at the "Select Tool" screen, highlight the row/tool for the wiPOD device you are using. Then select "Next" at bottom right side of the screen.

6. Enter your "User id" and "Password", then select "Finish" at the bottom of the screen.

7. From the "Vehicle View" screen, click on the PCM icon.

8. From the "PCM View" screen select the "Flash" tab, compare the "Current ECU Flash Number" with the "New Part Number" listed on the "sort table". If the "Current ECU Flash Number" is the same as the "New Part Number" continue to Step 13. If the part numbers are not the same, continue with Step 9.

9. With the cursor over flash file part number RC-N09-13, click the small green arrow button on the right side of the screen.

10. From the "Flash Tab" screen follow the wiTECH screen instructions to complete the flash.

11. Verify that all Diagnostic Trouble Codes (DTCs) have been cleared.

12. Turn the ignition to the "OFF" position and remove the wiTECH VCI pod and battery charger from the vehicle.

13. Continue with Section B. Install Authorized Modifications Label.

B. Install the Authorized Modifications Label:





1. Type or print (with a ballpoint pen) the recall number, repair modification, dealer code and date Reprogram PCM Module Reprogram ORC Module on the Authorized Modifications Label (Figure 1).

2. Attach the label near the VECI label and then close the hood.

3. Complete Proof of Correction Form for California Residents.

NOTE:
This recall is subject to the State of California Registration Renewal/Emissions Recall Enforcement Program. Complete a Vehicle Emission Recall Proof of Correction Form (Form No. 81-016-1053) and supply it to vehicle owners residing in the state of California. The correction form will provide proof that this recall has been performed when the owner renews the vehicle registration.