Disassembly

1. Remove the dust seal from the rear of the valve housing using Puller Attachment T58L-1O1-B, and Slide Hammer T59L-1O0-B. Discard the seal.
2. Remove the snap ring from the valve housing.
3. Turn the bench mounted holding fixture to invert valve housing.





4. Insert Tool T65P-3524-A2 and T65P-3624-A3 from the Input Shaft Bearing seal Tool in the valve body assembly opposite the oil seal end and gently tap the bearing and seal out of the housing. Discard the seal. Do not damage the housing. when Inserting and removing the tool.
5. Remove the fluid inlet and outlet tube seats with Tube seat Remover T74P-35O4-L if they are damaged.