Borg Warner 1359 Inline

Fig. 5 Transfer case retaining bolt tightening sequence.:

1. Raise and support vehicle, then disconnect rear driveshaft from transfer case output shaft flange.
2. Disconnect speedometer cable from case rear cover, then support case assembly with suitable jack.
3. Remove transfer case to extension housing retaining bolts.
4. Slide transfer case rearward until it clears transmission output shaft, then lower transfer case and remove vehicle.
5. Reverse procedure to install and note the following:
a. Torque transfer case retaining bolts to 25---43 ft. lbs. in sequence shown in Fig. 5.
b. Torque speedometer cable retaining screw to 20---25 inch lbs.
c. Torque rear driveshaft to transfer case output shaft flange bolts to 61---87 ft. lbs.