Power Window Motor: Service and Repair

Power Window Motor
Removal
1. Disconnect the battery ground cable.
2. Remove the door trim panel.






3. Disconnect power window motor wire from wire harness connector (Fig. 10).
4. Check inside the door to ensure electrical wires are not in line with holes to be drilled in the door inner panel. Using a 12.7mm (1 /2-inch) diameter drill bit drill two holes in the door inner panel at the drill dimples located opposite the two unexposed motor drive retainer screws (Fig. 10).
5. Remove the three motor mount retainer screws using two drilled holes and existing larger hole access to screw heads (Fig. 10).
6. Push the motor toward the outside sheet metal to disengage Ihe motor and drive from the regulator gear. After the motor and drive are disengaged prop the window in full UP position.
7. Remove the motor and drive from inside the door.

Installation
1. Instal a new motor and drive assembly (Fig. 10). Tighten motor retaining screws to 5.6-9.6 N.m (50-85 in-lb).
2. Install two pieces of Pressure-Sensitive Waterproof Tape D6AZ-19627-A or equivalent body tape (1 inch square) over drilled holes.
3. Connect power window motor wiring, and battery ground cable.
4. Remove glass prop and check window operation.
5. Ensure door drain holes are open.
6. Install trim panel.