Star Tester & Self-Test Connector Hook-Up

STAR TESTER HOOK UP

STAR tester & self-test electrical connector assembly:

The self-test connector and tester hook-up is identical on all models. A two piece self-test connector on the vehicle, plugs into a matching two-piece service connector at the end of the STAR/Self-Test adapter cable assembly. To connect the STAR tester proceed as follows:

1. Turn ignition switch to OFF position.
2. Connect the color-coded adapter cable leads on to the STAR tester.

Connecting STAR Tester:

3. Connect the adapter cables two service connectors to the matching self-test connectors on the vehicle.

Star Tester Display:

To check the STAR tester, turn the power switch, located on the right side of the tester to the ON position. The tester will run a display check and the numerals 88 will begin to flash. A steady 00 will then appear to signify that the tester is ready to start the self-test and receive service codes.