Installation

1. Coat the bearing with differential lube for easier assembly and to prevent possible scoring of the tube bore.

2. Install bearing in the tube bore using Push- Puller T81P-1104-C, Adapters T81P-1104-B or D81 T-1104-A, Step Plate D8OL-630-1 and Rear Axle Bearing Replacer T8OT-4000-X.

NOTE: When installing bearing make sure the bearing is not cocked in the bore during installation.

3. Install a new oil seal in the bore using Push Puller T81P-1104-C, Adapters T81P-1104-B or D81T-1104-A, Step Plate D8OL-630-1 and Rear Oil Seal Replacer T8OT-4000-Y, as shown. An alternate method of installing the seal is to drive the seal into place with Rear Oil Seal Replacer T8OT-4000-Y and Driver Handle, TBOT-4000-W.

NOTE: Make sure the seal is not cocked in the bore during installation.

4. Lubricate cavity between seal lips and bearing with Long-Life Lubricant C1AZ-19590-BA (ESA-M1C75-B).

5. Install axle shafts.