Removal and Installation
REMOVAL1. Apply parking brake and disconnect battery ground cable.
2. Remove bolt and nut attaching intermediate shaft to steering column.
3. Disconnect shift linkage rod(s) from column.
4. Remove screws from underneath steering wheel, then lift horn switch assembly from steering wheel.
5. Disconnect horn switch wires by pulling spade terminal from blade connectors, then squeeze J-clip ground wire terminal and pull it out of hole in steering wheel.
6. Remove horn switch assembly, then the steering wheel retaining nut.
7. Using suitable puller, remove steering wheel from shaft. When servicing a tilt steering column, the steering wheel must be in the full Up position when removed.
8. Remove steering column floor opening cover plate screws.
9. Remove shroud by loosening screw at bottom, selecting position 1 on manual three speeds and automatics and spreading shroud open, and withdrawing out of instrument panel opening while pulling up and away from column.
10. On vehicles with automatic transmission, remove shift lever cable.
11. On all models, remove instrument panel column opening cover.
12. Remove column support bracket to pedal support bracket attaching bolts.
13. Disconnect turn signal/hazard warning and ignition switch wiring harnesses.
14. Remove column from vehicle, then the column support bracket from column.
INSTALLATION
1. Attach steering column support bracket, ensuring that turn signal/hazard warning wiring is on outboard side of column, torquing nuts to 13-38 ft. lbs.
2. Hand start floor opening cover plate clamp bolt and press plate until clamp flats abut stops on column outer tube.
3. Load column into vehicle through opening in floor.
4. Connect turn signal/hazard warning and ignition switch wiring harnesses.
5. Raise column to pedal support bracket and hand start two bolts.
6. Fasten floor opening cover plate to floor, torquing screws to 6-10 ft. lbs.
7. Torque two support bracket bolts to 19-27 ft. lbs. and the cover plate clamp bolt to 8-18 ft. lbs.
8. On vehicles with automatic transmission, install and adjust shift lever cable.
9. On all models, install instrument panel steering column opening cover.
10. Mount shroud by selecting position 1 on three speed manuals and automatics, spreading shroud around steering column and through opening in instrument panel. Post on interior will index shroud when properly positioned.
11. Torque screw at bottom of shroud to 10-15 inch lbs.
12. Attach shift linkage rod(s) to column.
13. Connect intermediate shaft to steering column, torquing bolts to 35-50 ft. lbs.
14. Position steering wheel into place with retaining nut, then torque nut to 30-40 ft. lbs. and steering wheel pad to 7-11 inch lbs.
15. Connect spade terminal of horn switch wire to blade connector and press J-clip ground terminal fully into threaded hole.
16. Center horn switch on steering wheel and install attaching screws.
17. Connect battery ground cable.