Cylinder Head Assembly: Service and Repair

Fig. 17 Cylinder head bolt tightening sequence:

Fig. 14 Intake manifold bolt tightening sequence:

1. Remove intake manifold.
2. Remove rocker arm covers.
3. If removing right cylinder head, perform the following steps:
a. Remove the alternator and air pump mounting bracket bolt and pivot alternator downward.
b. On Econoline models, remove ignition coil and air cleaner inlet duct from cylinder head.
4. On all models, if removing left cylinder head, perform the following steps:
a. On models with A/C, remove A/C compressor bracket attaching bolts.
b. On F-Series models, remove oil dipstick and tube assembly and speed control bracket, if equipped.
5. On all models, disconnect exhaust pipes from exhaust manifolds.
6. Loosen rocker arm studs or bolts and remove push rods in sequence so they may be installed in their original positions.
7. On Econoline models, remove Thermactor air supply manifold, hose and pump valve as an assembly.
8. On Bronco and F-Series models, disconnect Thermactor air supply hoses from check valves and plug the valves.
9. On all models, remove cylinder head attaching bolts and the cylinder head.
10. Reverse procedure to install. Tighten cylinder head attaching bolts in sequence shown in Fig. 17. Tighten intake manifold attaching bolts in sequence shown in Fig. 14.