Control Module Self Test, Borg-Warner 13-56

The electronic control module has a diagnostic capability of its internal circuitry. Self test procedure is as follows:
1. Disconnect five-wire and eight wire connectors from electronic control module.
2. Turn ignition switch to the RUN position.
3. Activate the self test switch and note result:

Control Module Self Test:

NOTE: The self test switch and indicator light is located on the Electronic Control Module.

A FLASHING INDICATOR LAMP, (approximately one flash per second), indicates control module is functioning properly.

A STEADY INDICATOR LIGHT, indicates that control module is inoperative and must be replaced.