Eight-Wire Harness Connector

Eight-Wire Harness Connector:

Eight-Wire Harness Connector

1. Connect an ohmmeter between terminal 1 and ground. Shift the transmission into the NEUTRAL position and observe the ohmmeter. The ohmmeter should indicate less than 50 ohms while the transmission selector lever is in the NEUTRAL position.

2. Connect an ohmmeter between terminals 2 and 3. The ohmmeter should indicate 200-350 ohms. This will check the continuity of the speed sensor that is located in the transfer case.

3. Connect an ohmmeter between terminal 8 and terminals 4, 5, 6, and 7, respectively. Refer to the following chart for the appropriate ohmmeter readings in each transfer case position.