Air Bag Warnings and Safety Instructions

General Instructions
- Air bag modules with discolored or damaged cover deployment doors must be replaced, not repainted.
- Because of the critical operating requirements of the system, do not attempt to service sensors, clockspring, monitor, backup power supply or air bag. Service is made by replacement only.
- If a part is replaced and the new part does not correct the condition, install the original part and perform the diagnostic procedure again.

- Never probe the connectors on the air bags. Doing so may result in air bag deployment which could result in personal injury.
- All component replacements and wiring being serviced must be made with the positive battery cable disconnected for a minimum of one minute before service or replacement is attempted.

The instruction "disconnect" always refers to a connector. Never detach a component from the vehicle when instructed to "disconnect."

Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag system is involved in a crash where the radiator support or frame have been damaged, the sensor should be replaced whether or not the air bag is deployed. In addition, make sure that body structure in the area of sensor mounting is restored to its original condition.