Engine Harness - Connector Removal Procedures

Article No.
92-19-8

09/09/92

WIRING - 4.9L, 5.0L, 5.8L, 7.5L ENGINE HARNESS - 42 - WAY CONNECTOR REMOVAL PROCEDURE

LIGHT TRUCK:
1992 BRONCO, F SUPER DUTY, F-150-350 SERIES

ISSUE:
The power network box bracket has been redesigned to accommodate the 42-way connector. It is located between the (12A581) engine compartment wiring harness and the (9D930) engine wiring harness on top of the engine.

ACTION:
A procedure has been developed for removing the 42-way connector. Remove the 42-way connector by using the following service procedure.








1. Position the blade of a screwdriver between the tab and bracket (F2TZ-14A254-B), Figure 1.

2. Twist the screwdriver slightly, then slide the connector (F2TZ-14489-C) toward the screwdriver.

3. Slide the connector to the end of the slot, then move the connector up and out of the bracket.

OTHER APPLICABLE ARTICLES:
NONE

WARRANTY STATUS:
INFORMATION ONLY

OASIS CODES:
203200, 290000