Parking Brake - Service Procedure

Article No.
00-1-3

01/10/00

PARKING BRAKE - PROCEDURE FOR SERVICING PARKING BRAKE - SERVICE TIP - BRONCO AND F-SERIES BUILT THROUGH 4/22/1994 AND EXPLORER/RANGER BUILT THROUGH 5/13/1994

FORD:
1992-1994 BRONCO, F-150-350 SERIES
1993-1994 EXPLORER, RANGER

ISSUE
When servicing the parking brake or service brake systems where the lock-in wedge has been installed in the parking brake control, additional service procedures will be necessary.

ACTION
When a lock-in wedge part has been previously installed in the parking brake control assembly, it must be removed prior to conducting maintenance procedures from the appropriate Service Manual, Sections 06-04 (Rear Drum Brakes) and 06-05 (Parking Brake System). The wedge must be reinstalled after service is completed. Refer to Service Recall Bulletin 94S91-S3 for lock-in wedge part removal and installation detailed service procedures, part numbers, and diagrams. Be sure to inspect the wedge for damage. If any part of the wedge is broken or damaged, install a new wedge.

OTHER APPLICABLE ARTICLES: 94S91-S3
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 301000, 302000