Five-Wire Harness Connector

Five-Wire Harness Connector:

Five-Wire Harness Connector

1. Connect an ohmmeter between terminals 1 and 2. Then depress the 4x4,(2H-4H) switch in the electronic switch control. The ohmmeter should indicate less than 50 ohms while the switch is being depressed.

2. Connect an ohmmeter between terminals 1 and 3. Then depress the LOW,RANGE switch to the right of the steering column. The ohmmeter should indicate less than 50 ohms while the switch is being depressed.

NOTE: The next two checks are to be made with the battery cables connected securely to battery terminals.

3. Connect a test lead between terminal 4 and ground. Turn the ignition switch to the RUN position and observe the electronic switch control. The LOW RANGE indicator light should illuminate.

4. Connect a test lead between terminal 5 and ground. Turn the ignition switch to the RUN position and observe the electronic switch control. The "4x4" indicator light should illuminate.