Accelerator Pedal: Service and Repair

REMOVAL

1. Remove accelerator cable from accelerator pedal and shaft.

2. Remove the screws holding the accelerator pedal and shaft to the instrument panel.

3. Remove the accelerator pedal and shaft from the instrument panel.

INSTALLATION

1. Position accelerator pedal and shaft to instrument panel and install lower screw hand tight.

2. Install upper screw and tighten to 21-29 Nm (15-21 lb ft).

3. Install middle screw and tighten to 21-29 Nm (15-21 lb ft).

4. Tighten lower screw to 21-29 Nm (15-21 lb ft).

5. Snap all accelerator cable into slotted hole in accelerator pedal and shaft.