A/T - E4OD/C6 Low One-Way Clutch Service Tips

Article No.: 94-8-20

^ TRANSMISSION - E40D AND C-6 - INSTALLATION INSTRUCTIONS FOR "NEW UNITIZED PLASTIC CAGE" LOW ONE-WAY CLUTCH - 1989-94 MODELS WITH E40D AND ALL MODEL YEARS WITH C-6

^ TRANSMISSION - E40D AND C-6 - NO FORWARD ENGAGEMENT - SERVICE TIPS FOR INSTALLING "NEW UNITIZED PLASTIC CAGE" LOW ONE-WAY CLUTCH - 1989-94 MODELS WITH E40D AND ALL MODEL YEARS WITH C-6

LIGHT TRUCK:
1989-94 BRONCO, ECONOLINE, F SUPER DUTY, F-150-350 SERIES, F-53

ISSUE:
A no forward engagement concern may be caused by an incorrectly installed "New Unitized Plastic Cage" Low One-Way Clutch.

ACTION:
Use the following procedure any time the Low One-Way Clutch is replaced using the "New Unitized Plastic Cage" Assembly.

REMOVAL PROCEDURE





1. Remove the upper retaining ring, brass bushing, one-way clutch assembly and lower retaining ring, Figure 1.

2. Discard all removed parts.

INSTALLATION PROCEDURE

1. Install "New Unitized Plastic Cage" Low One-Way Clutch Assembly (F3TZ-7A089-A) into the rear of the Reverse Clutch Hub assembly.

NOTE:
DO NOT USE BRASO BUSHING (7E193) OR UPPER AND/OR LOWER RETAINING RINGS WITH THE "NEW UNITIZED PLASTIC CAGE" LOW ONE-WAY CLUTCH. THE TABS ON THE CAGE WILL HOLD THE CLUTCH IN PLACE.





2. Rotate the One-Way Clutch Assembly clockwise to lock tabs on "Plastic Cage" and fully seat the One-Way Clutch in place, Figure 2.

PART NUMBER PART NAME CLASS

F3TZ-7A089-A Low One-Way Clutch Assembly A

OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 503000