Scan Tool Testing and Procedures

CAUTION: When checking resistance in the RABS II system, always disconnect the battery ground cable. Improper resistance readings may occur with the vehicle battery connected.

NOTE: Refer to Obtaining the Diagnostic Trouble Code in this section for procedure to obtain flashout code. Displaying and Reading Trouble Codes


DIAGNOSTIC CONDITION ACTION TO TAKE
TROUBLE CODE

2 Open RABS Isolation See Pinpoint Test Code 2.
Solenoid Circuit 2

3 Open RABS Dump See Pinpoint Test Code 3.
Solenoid Circuit 3

4 [1] Open/grounded See Pinpoint Test Code 4.
Valve Reset Circuit 4

5 Excessive Dump See Pinpoint Test Code 5.
Solenoid Activity 5

6 Erratic Speed Sensor See Pinpoint Test Code 6.
Circuit 6

7 No Isolation Solenoid See Pinpoint Test Code 7.
During self-check 7

8 No dump solenoid See Pinpoint Test Code 8.
During Self-check 8

9 High Speed Sensor See Pinpoint Test Code 9.
Resistance 9

10 Low speed sensor See Pinpoint Test Code 10.
Resistance 10

11 Stoplamp Circuit See Pinpoint Test Code 11.
Always Closed 11

12 Loss Of Hydraulic Fluid See Pinpoint Test Code 12.
During antilock Stop 12

13 Antilock Electrical See Pinpoint Test Code 13.
Control Unit Failure 13

16 or more. Drive test. See Pinpoint Test Code 16.
16



[1] - Red brake warning lamp illuminated.