KB9 - Check CANP Circuit For Short to Power

- Key "OFF".

- Canister Purge (CANP) valve disconnected.

- Breakout box installed, Powertrain Control Module (PCM) disconnected.

- Measure resistance between test pin 11 and test pins 37 and 57 at the breakout box.

- Is each resistance greater than 10,000 ohms?

Yes -- Go to KB10. KB10 - Check CANP Circuit For Short to Ground

No -- Service short in harness. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)