E2 Check Proper Valve Resistance at Control Module Connector

- Install 60-pin breakout box. Make sure the correct Econoline 4WABS overlay is installed.

- Measure valve resistance between 60-pin breakout box Pins 30 and 37.

- What resistance is measured?

Less than 3 ohms and Code C1216 was obtained. Low resistance detected. Go to E5 to determine fault location. E5 Determine Location of Resistance Fault

3-6 ohms and Code C1214 or C1216 was obtained. Go to E3. E3 Check For Intermittent In Short to Ground

More than 6 ohms and Code C1214 was obtained. High resistance detected. Go to E5 to determine fault location. E5 Determine Location of Resistance Fault