G2 Verify Integrity of Electronic Control Module Connection

- Turn ignition to the OFF position.

- Disconnect battery ground cable.

- Remove the antilock electronic control module connector.

- Inspect antilock electronic control unit Pins 8 and 14.

- Pull gently on each wire just behind Pins 8 and 14 on harness connector.

- Are connections clean and secure?

YES -- Leave antilock electronic control module connector disconnected. Go to G3.

NO -- Terminal(s) in antilock electronic control module connector are loose, bent, deformed, corroded, or missing. Service terminal or connector as needed. if not serviceable, Replace antilock electronic control module. Go to G6.

NO -- Terminals 8 or 14 in antilock electronic control module harness connector move back or come free of connector. Service terminal or connector as needed. Go to G6.