Keyless Entry Transmitter: Description and Operation
NOTE: The remote entry features will not function when the ignition switch is in the RUN or ACC position.
The keyless entry remote transmitters:
^ Are reprogrammable.
^ Must be set at the same time.
To unlock the driver door:
^ Press the UNLOCK button on the keyless entry remote transmitter.
NOTE: If more than five seconds have elapsed since the first press of the UNLOCK button, pressing the UNLOCK button again will only unlock the driver door a second time.
To unlock all doors:
^ Press the UNLOCK button on the keyless entry remote transmitter a second time, within five seconds of the first unlock.
To lock all doors:
^ Press the LOCK button on the keyless entry remote transmitter once.
^ Press the LOCK button again, within five seconds of the first press. The horn will chirp once if the doors have locked and all doors are closed. The horn will chirp twice if a door is open, indicating that the anti-theft system will not arm until all the doors are closed.
To confirm that the doors have been locked:
^ Press the LOCK button again, within five seconds of the first press. The horn will chirp once.
To activate the panic alarm:
^ Press the red PANIC button on the keyless entry remote transmitter. The horn will sound and the headlamps and exterior lamps will flash for a maximum of two minutes and 45 seconds.
To deactivate the panic alarm:
^ Press the red PANIC button again on the keyless entry remote transmitter.
^ Turn the ignition switch to RUN/ACC.
Inputs and Outputs
The RAP module receives input from the following components for electronic door lock system operation:
^ Keyless entry remote transmitters.
^ Door ajar output from the GEM.
^ Brake on/off switch.
^ Transmission range (TR) sensor.
^ Remote entry antenna.
The RAP module distributes output to the following for the electronic door lock system:
^ Driver unlock relay.
^ All unlock relay.
^ All lock relay.
^ Horn relay.
^ Headlamp relay.
^ Park lamp relay.
^ Illuminated entry request output to the GEM.