Disassembly

1. Remove the ignition switch lock cylinder.
2. Remove the air bag sliding contact.
3. Remove the steering column.





4. Remove the bearing retainer.

CAUTION: Carefully note the position of the steering column lock gear, bearing and retainer prior to removal.





5. Remove the steering column lock housing bearing.





6. Remove the steering column lock gear.





7. Remove the shock absorber electronic steering sensor.
(1) Disconnect the electrical connector.
(2) Remove the screws.
(3) Remove the shock absorber electronic steering sensor.





8. On tilt steering column equipped vehicles, remove the sensor ring.
(1) Remove the steering column lower bearing spring.
(2) Remove the sensor ring.





9. On fixed steering column equipped vehicles, remove the snap ring from the bottom of the steering column shaft.





10. Remove the steering column bearing tolerance ring from the steering column shaft.





11. Remove the two lock cylinder housing pivot screws.





12. Remove the steering column lock cylinder housing and the steering column shaft from the steering actuator housing.
(1) Pry up on the steering column locking levers using a shop fabricated tool.
(2) On tilt steering columns, remove the steering column position spring.

WARNING: THE STEERING COLUMN POSITION SPRING IS UNDER TENSION AND MAY COME OUT WITH GREAT FORCE.





13. Remove the snap ring.





14. Remove the steering column upper bearing spring.





15. Remove the steering column bearing sleeve.





16. Remove the steering column bearing tolerance ring.
(1) Slide the steering column shaft in toward the steering column lock cylinder housing, then out.
(2) Slide the steering column bearing tolerance ring off the steering column shaft.





17. Using a suitable punch, remove the steering column bearing from the steering column lock cylinder housing.





18. On tilt steering columns, use a suitable punch to remove the steering column bearing from the steering column lock cylinder housing.





19. Remove the brake shift interlock solenoid.
(1) Remove the three bolts.
(2) Remove the brake shift interlock solenoid.





20. Remove the shift tube.
(1) Remove the four bolts.
(2) Remove the two shift tube clamps.
(3) Remove the shift tube.





21. Remove the transmission selector lever arm and support.
(1) Remove the two bolts.
(2) Remove the transmission selector lever arm and support.





22. Remove the gearshift selector tube spring.





23. Drive out the gearshift lever pin from the shift tube.





24. Remove the gearshift lever.





25. Remove the column shift selector lever plunger.
- If it is bent, replace the column shift selector lever plunger.





26. Remove the two gearshift lever socket bushings and the transmission control selector lever spring clip.





27. Remove the steering column lock pawl.
(1) Drive out the steering column lock lever pin.
(2) Remove the steering column lock pawl.





28. Remove the ignition switch.
(1) Remove the bolts.
(2) Remove the ignition switch.





29. Remove the lower steering column bearing and sleeve.





30. Remove the steering column lower bearing retainer.
(1) Remove the three bolts.
(2) Remove the steering column lower bearing retainer.





31. Remove the upper steering column lock actuator and the lower steering column lock actuator.