Front

REMOVAL
1. Disconnect the battery ground cable(s).

WARNING
- THE BELT AND BUCKLE ASSEMBLY PRETENSIONER IS A PYROTECHNIC DEVICE. ALWAYS WEAR SAFETY GLASSES WHEN SERVICING AN AIR BAG-EQUIPPED VEHICLE AND WHEN HANDLING A BELT AND BUCKLE ASSEMBLY PRETENSIONER.
- THE BELT AND BUCKLE ASSEMBLY PRETENSIONER IS A PYROTECHNIC DEVICE. NEVER PROBE THE CONNECTORS ON THE BELT AND BUCKLE ASSEMBLY PRETENSIONER. DOING SO CAN RESULT IN BELT AND BUCKLE ASSEMBLY PRETENSIONER OR AIR BAG DEPLOYMENT AND CAN RESULT IN PERSONAL INJURY.
- TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST BE DEPLETED BEFORE REPAIRING OR REPLACING ANY AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) COMPONENTS. TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF SO EQUIPPED).

NOTE: Be sure to disconnect auxiliary batteries and power supplies (if so equipped).







2. Remove the seat support bolts and nuts retaining the front seat support to the floor.
1 Remove the stud cover.
2 Remove the nuts and washers.
3 Remove the bolts.
4 Disconnect the belt and buckle assembly pretensioner connector.







3. Disconnect the electrical feed connector underneath the seat.
4. Remove the front seat.

INSTALLATION






1. Follow the removal procedure in reverse order.