Ignition Key In Signal: Service and Repair

REMOVAL







1. Disconnect the battery ground cable.

CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.







2. Remove the ignition switch lock cylinder.
1 Insert the ignition key and turn to the RUN position.
2 Press the (A) ignition switch lock cylinder release tab while pulling out the (B) ignition switch lock cylinder.







3. Remove the key in ignition warning switch.
1 Pry the clip downward.
2 Release the key-in-ignition warning switch from the rear of the ignition switch lock cylinder.







INSTALLATION
1. To install, reverse the removal procedure.

NOTE: when the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.