Transmission Position Sensor/Switch: Service and Repair

Special Tools:

1. If equipped, turn the air suspension switch OFF.
2. Disconnect the battery ground cable.
3. Raise the vehicle on a hoist.





4. Disconnect the manual lever shift control cable.
5. Disconnect the digital TR electrical connector.





6. CAUTION: Discard outer manual control lever shaft nut. Do not reuse. The old nut will not retain torque specification.

Remove the manual control lever.
1 Remove the nut.
2 Remove the lever.

7. Loosen the digital TR bolts.





8. NOTE: Manual shift lever must be in the neutral position.

Use digital Transmission Range (TR) Sensor Alignment Tool, to align the digital TR sensor slots.





9. Tighten the bolts.





10. Install the manual control lever.
1 Position the manual control lever.
2 Install a new manual lever shaft outer nut.





11. With the manual lever in overdrive connect the shift lever control cable.
12. Install the digital TR sensor electrical connector.
13. Lower the vehicle.
14. Connect the battery ground cable.
15. If equipped with air suspension, reactivate the system by turning on the air suspension switch.