Shoulder Safety Belt Height Adjuster With Stripped Weld Nuts

1. Remove the B-pillar trim panel.




2. Use the half-inch drill provided in the D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.
3. Apply a suitable lubricant to the M14x1.5 tap provided in the D-Ring Installation Kit and tap new threads.

NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before preceding.




4. Use a threaded insert provided in the D-Ring Installation Kit and screw it into the retapped hole until it is slightly below the surface.




5. Use a hammer to lightly tap the installation tool provided in the D-Ring Installation Kit several times to seat the insert keys.

NOTE: If the two bolts or the height adjuster are not stripped, install the height adjuster.If the bolts are stripped, replace the height adjuster.

6. Install the B-pillar trim panel. Check the restraint system for normal operation.