Front

REMOVAL
1. Remove the front disc brake rotor.





2. Remove the three bolts and the dust shield.





3. Remove the wheel hub retainer nut and washer assembly.

CAUTION: Discard the wheel hub retainer nut and washer assembly. It is a torque prevailing design and cannot be reused.





4. Remove the front brake anti-lock sensor.
(1) Remove the bolt.
(2) Remove the front brake anti-lock sensor.





5. Remove the three bolts and the wheel hub.

CAUTION: Do not overextend CV joint and boots when removing the hub and bearing assembly.

NOTE: The CV joint is a slip fit into the wheel hub and bearing. A puller will not normally be required.





6. Remove the seal.

INSTALLATION





1. Install the seal.
- Using the Knuckle Seal Replacer, Threaded Drawbar and Bearing Cup Replacer, install the seal.





2. Install the wheel hub.
- Position the wheel hub on the front wheel driveshaft and joint and into the front wheel knuckle. Install the three bolts.





3. Install the dust shield.





4. Install the front brake anti-lock sensor.
(1) Position the front brake anti-lock sensor.
(2) Install the bolt.





5. Install the wheel hub retainer nut and washer assembly.
6. Install the front disc brake rotor.