Flow of Diagnosis

NOTE: Do not take short cuts or assume that critical checks or adjustments have already been made.

Troubleshooting an electronically controlled automatic transmission is simplified by using the proven method of diagnosis. One of the most important things to remember is that there is a definite procedure to follow.

Follow the procedures as written to avoid missing critical components or steps.

To diagnose a concern properly, the technician should have the Technical Service Bulletins (TSBs).

Diagnostic Flow Chart:

Using the Diagnostic Flow Chart as a guide, follow the steps as indicated.

PRELIMINARY INSPECTION
- Know and understand the customer's concern.
- Check the fluid level and condition.
- Verify the concern by operating the vehicle.
- Check for non-factory add-on items.
- Check shift linkages for proper adjustment.
- Check Technical Service Bulletins (TSBs) for the concern.

DIAGNOSTICS
- Perform on-board diagnostic procedures Key On Engine Off (KOEO) and Key On Engine Running (KOER).
- Record all Diagnostic Trouble Codes (DTCs).
- Repair all non-transmission codes first.
- Repair all transmission codes second.
- Erase all continuous codes and attempt to repeat them.
- Repair all continuous codes which reappear.
- If only pass codes are obtained, proceed to Diagnosis by Symptom Index for further information and diagnosis. Diagnosis By Symptom Index

Follow the diagnostic sequence to diagnose and repair the concern the first time.