Installation

1. Attach the Modular Lifting Bar.
2. Remove the engine from the engine stand.
3. Clean and inspect the mating surface.

CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the aluminum retainer plate. These tools cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.





4. Apply a bead of silicone around the rear oil seal retainer sealing surface.
- Use Silicone Gasket and Sealant F6AZ-19562-A or equivalent meeting Ford specification WSE-M4G323-A6.

NOTE: If not secured within four minutes, sealant must be removed and sealing area cleaned with Metal Surface Cleaner F4AZ-19B536-RA or equivalent meeting Ford specification WSE-MSB392-A. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure can cause future oil leakage.





5. Install the crankshaft rear oil seal retainer and bolts.





6. Install a new crankshaft rear oil seal.
7. Install the crankshaft oil slinger.





8. Install the flywheel and the bolts. Tighten the bolts in the sequence shown.

NOTE: Align the engine to transmission dowels before installing engine to transmission bolts.

9. Position the engine in the vehicle, and remove the engine lifting bar and the jack supporting the transmission.
10. Raise and support the vehicle.





11. Position and install and the LH engine mount.





12. Position and install the RH engine mount.





13. Install and tighten the new nuts.
14. Install the starter motor.





15. Install and tighten the four nuts.





16. Install the bolts.





17. Install the oil cooler to the oil filter adapter, and install the oil bypass filter.





18. Install the bolts and bracket. Install the shifter cable.





19. Install the lower radiator hose.
20. Lower the vehicle.





21. Install the transmission oil filler tube and nut.

NOTE Lubricate the O-rings with transmission fluid.





22. Install the remaining bracket bolts and the fuel line.





23. Connect the transmission wiring harness and the LH and RH heated exhaust gas oxygen sensor connectors.





24. Install the water heater return tube.
25. Install the intake manifold.





26. Install the suction line to the accumulator.
27. Install the drive belt.
28. Install the A/C condenser.
29. Install the radiator.
30. Install the engine air cleaner (ACL) and the air cleaner outlet tube.





31. Install the power steering reservoir bracket.
32. Fill all fluids to the proper levels.
33. Connect bulkhead connectors.
- Tighten the bolt.





34. Install the connector cover.
35. Install the hood.
36. Connect the battery ground cable.
37. Start the engine and check for leaks. Stop the engine and recheck the fluid levels.
38. Recharge the A/C system.