Transmission Position Sensor/Switch: Adjustments

Special Tools:

ADJUSTMENT PROCEDURE
1. Raise and support vehicle.





2. Disconnect the manual lever shift control cable.
3. Disconnect the digital Transmission Range (TR) electrical connector.





4. Remove the manual control lever.
1 Remove the nut.
2 Remove the lever.

CAUTION: Discard outer manual control lever shaft nut. Do not reuse. The old nut will not retain torque specification.

5. Loosen the digital TR sensor bolts.





6. Use Digital TR Sensor Alignment Tool, to align the digital TR sensor slots.

NOTE: Manual shift lever must be in the neutral position.





7. Tighten the bolts.





8. Install the manual control lever.
1 Position the manual control lever.
2 Install a new manual lever shaft outer nut.





9. With the manual lever in overdrive connect the shift lever control cable.
10. Install the digital TR sensor electrical connector.
11. Lower the vehicle.